DIN 13260-2 Type

We design and manufacture our
DIN 13260-2 Type Medical Gas Outlet
(Terminal Unit) to last and to ensure a
constant and reliable medical gas flow
for the patient and the medical equipment.

All outlets are 100 % tested for flow,
and leakage and are cleaned for
oxygen services before shipping.

Our DIN 13260-2 Type outlets are designed by
industrial designers to ensure an appealing
and pleasant environment for the
patient and the medical staff.

Downloads:

Spec Sheets
  • Accepts DIN 13260-2 gas-specific adapters.
  • All medical gas outlets are 100%
    hydrostatic tested     for leaks.
    The outlets are factory-assembled    , 
    degreased, and cleaned for     medical
    gas service.
  • Indexed to eliminate interchangeability
    of     gas services.
  • 360-degree swivel inlet pipe
    for ease of installation.
  • Double position allowing parking of
    male     adapter in the outlet.
  • Low maintenance due to the use of
    VITON seals     in front assembly (latch value).



  • Medical Gas System Standards:
    • NFPA99 & EN ISO 7396-1 requirements.

  • Applicable Standards:
    • ISO 9170-1, DIN 13260-2.
  • Silbermann's Quality Management System:
    • CE marked by the notified body TÜV-SÜD.


  • The medical gas outlet shall be 
    SILBERMANN DIN type manufactured     according to
    ISO 9170-1 DIN 13260-2.
  • The outlet shall be gas-specific by
    indexing     each front service panel to
    a gas-specific pin-indexed     rough-in module.
  • The outlet of positive and negative
    pressure     shall consist of a primary and
    secondary     check valves to allow testing
    and online     maintenance.
  • Outlet shall be manufactured with
    175 mm     long, type K, 12.7 mm (1/2”) OD copper pipe.
    Rough-in pipe shall be silver brazed to
    the outlet body.
  • With the rough-in mounted, the outlet
    shall be     depth adjustable to compensate
    for     various wall thicknesses.
  • The quick-connect outlet shall comply
    with     ISO 9170-1 standard type and
    accept only     corresponding DIN 13260-2
    Gas Specific     Adapter.
  • Pressure drop of less than 20 Kpa
    through     the outlet at 120 LPM and
    350 Kpa (3.5 Bar)     inlet pressure.
  • When fully open, the outlet allows a low
    of up     to 600LPM and pressure of 400 KPa (4 Bars).
Related products